//=============================================================================

  EXT-HDKVM-LAN, EXT-DVIKVM-LAN, EXT-DVIKVM-LAN-L, EXT-HD2IRS-LAN


//=============================================================================
	Release Notes FW Version 1.92
//=============================================================================

- Added compatibility with new generation LAN products
- Added "Channel_pool" command to limit channel switching
- Added Syner-G read-only/write-read commands
- Added WEBGUI password change reboot warning
- Fixed IE11 WEBGUI issue on a system reboot, causing network and function pages to be blank

//=============================================================================
	Release Notes FW Version 1.85
//=============================================================================

- Add Audio clock lock function (Resolves issues with displays not meeting to HDMI audio spec and causing intermittent audio pops)
- Fix channel switching via front panel where channels were not changing in numerical order
- HTTP updates for EXT-CU-LAN (for video improvement) 


//=============================================================================
	Release Notes FW Version 1.70
//=============================================================================


All types:
- Support for up to 39,900 Channels

Senders:
- Remove Low/Medium/High Picture quality option from web GUI and from mode button selection.

Receivers:
- Add web GUI option to set the boot up and no-signal logo images. Gefen logo is set as default.
- Add web GUI  option to show/hide link status and IP addresses info on the no-signal screen.
- Fix incorrect refresh rate bug
- VGA only: Turn off display on DHCP signal
- Remove following warnings: "Unsupported Resolution"  and "Suggest 60Hz Refresh Rate. Please Change Video Source Setup"




//=============================================================================
	Release Notes FW Version 1.63
//=============================================================================


- Adds "Mask" function for Receiver
- Adds "Block" function for Sender




//=============================================================================
	Release Notes FW Version 1.53
//=============================================================================


- This firmware is specifically designed to allow the Sender/Receiver to work with the EXT-CU-LAN Video over IP controller
- Added Telnet and UDP access enable/disable option to web interface and TCP/UDP commands
- Added UDP Echo enable/disable to web interface and TCP/UDP commands
- Added Discovery and Show me enable/disable.
- Receiver Channel selection with front button only cycles to existing Sender channels.
- Sender Mode switch cycles through five modes  Graphics/Low-bw/Med-bw/Hi-bw/Video
- Added MTU switch between 8000 and 1500 to work with lower 
- Use of special characters ($, #, *, @,..etc.) used on the units description, should not affect the normal operation of the unit, or the operation of the EXT-CU-LAN.
